Revised Content:

3-Channel Visor Clip Remote Control for 318MHz Linear Megacode Mct-3 318MHz DNT00089

Before purchasing, please take note of the following:

This garage door remote is an aftermarket replacement, not a universal one. It ONLY works with 318MHz Megacode receivers. It is compatible with the following Linear Garage Door Openers: LDCO852, LDCO850, LDCO800, LSO50, LDO50, LDO33, and LCO75. It also works with the following Linear MegaCode Radio Receivers: MDR/U, MDR, MDR-2, MDRG, MDRM, MGR, MGR-2, SMDRG, AP-4, and AP-5 (in non-block code mode).

This remote is a replacement for the Linear Megacode MCT-3 DNT00089, ACT-31B ACP00879, and MCT-11 DNT00090 garage door remote controls. It does not support dip switch garage door openers or other brand and frequency receivers. It only works with 318MHz Linear Megacode receivers.

To set up the garage door remote, follow these 3 simple steps:

1. Locate the garage receiver and push the learn button on the opener. The light will blink.
2. Press any button on the remote that you wish to program.
3. The light on the opener will stop blinking, and the remote is now programmed.

You can repeat these steps to program multiple openers to this 3-button remote.

Product Details:

1. Number of Buttons: 3
2. Frequency: 318 MHz Megacode
3. Replacement aftermarket remote, not the original
4. Controls up to 3 Linear garage door or gate openers
5. Compatibility: Linear Megacode receivers 318MHz only
6. Programmable to radio receivers or garage door openers
7. Includes: 2 x 3V 2016 coin-cell batteries (installed), 1 programming manual, 1 visor clip, and 1 remote

Note: This is a replacement aftermarket remote, not a universal one. It ONLY works with "318MHz MEGACODE receivers." It will not work with other brands or frequencies.

product information: